PTO problems

Z

zeto

New member

Level 1

Joined

Aug 30, 2009

Messages

2

First name

zeto

• Aug 30, 2009

• #1

I have just bought a 6945 4wd. Have nearly figured out all controls except this. The pto shaft at the rear of the tractor is spinning but you can stop it with your hand. I hope i just haven't pulled the lever far enough back maybe, But the two speed selector seems to graunch a bit like it is going into gear. Any ideas?

 

F

forterra9641

Member

Level 1

Joined

Jul 29, 2006

Messages

453

First name

forterra11441

• Aug 30, 2009

• #2

This is perfectly normal. its the driveshaft for the hydraulic pump that is dragging the pto shaft along with it.

 

Z

zeto

New member

Level 1

Joined

Aug 30, 2009

Messages

2

First name

zeto

• Aug 30, 2009

• #3

i still cant get the shaft in gear though

 

S

swill

New member

Level 1

Joined

Sep 15, 2009

Messages

10

First name

newbee

• Sep 18, 2009

• #4

Turn the tractor off, then engage PTO, now pull the lever up to dis-engage the PTO and start the tractor. You should now be able to lower the PTO lever and your PTO should run.

 

S

swill

New member

Level 1

Joined

Sep 15, 2009

Messages

10

First name

newbee

• Sep 18, 2009

• #5

PS never leave the lever pulled up longer then 5 minutes when the tractor is running.

 

G

guntar

Member

Level 1

Joined

Aug 14, 2007

Messages

40

First name

Guntar (Doug)

• Sep 22, 2009

• #6

I have what I hope isn't dumb..

Does this explain why I can't stop PTO before engagement? Meaning I can't pull on lever and expect PTO to engage properly. This is while running.

The PTO brake is made to operate from OFF, then engage PTO, then start, then release brake, is this correct?

Thanks,
Doug

 

S

swill

New member

Level 1

Joined

Sep 15, 2009

Messages

10

First name

newbee

• Sep 24, 2009

• #7

No but I had the same problem so I did it the way I said and after that it started working the right way, maybe it was just stuck but at least I know now how to make it work if it does it again