• Hello Guest, you do not yet have the necessary rights to see the contents of our FAQ articles. Register in our forum, briefly introduce yourself and your Zetor in words and pictures and actively participate in discussions in the forum, then you will automatically receive access to the specialist articles in the FAQ.

Recent content by sb

  1. 8011 setting

    Hi all . am rebuilding the engine on a long 910 same as a 8011 . What are the big end torque setting and the head bolts . and also the tappets . thanks
  2. 8045 backwards 4wd

    You need to pull for 4wd . I think you might have the cable to long . When in 2wd the knob shud be down full . flush with the floor .
  3. Power steering problem

    hi shea , did you fit a new steering box or a second hand one . can you be sure the steering box you fitted is good
  4. Steering problem 8011(Please help)

    hi shea . AFTER the pump theres a relief valve . it dumps into the power steering tank . you need to pressure test this , the relief valve can be adjusted from the bottom . . did you check filter. also the front unit under the rad could be bad . never had one open but am told its a nightmare...
  5. local irish vintage tractor run recent photos

    hi what year is your crystal.
  6. Zetor 12045

    as dave said . i cant see how the back end oil can get into engine.
  7. Brakes bound 12145

    you should be able to see the adjuster at the back. on the axle . some had two nuts there either 19mm or 22mm tip that back gently towards front of tractor . you could back of adjuster a bit. not to much or the cylinders will pop out . which i have done .. the cylinders could be a bit rough...
  8. info URSUS 11054 - production started

    what are the specs of this tractor
  9. S

    question Long 910 tractor?

    it must be for the usa market.. . never heard of, or seen one before. very ugly tractor with that cab
  10. S

    question Long 910 tractor?

    hi all whats the story behind this tractor. its a crystal running gear.
  11. zetor 551 not firing on one cylinder

    take the rocker cover of and have a look in . check the pushrods
  12. 16145 wont stay in second

    ya am wondering about that to . i had a 1224t with a torque multiplier . there seems to be a lot of torque multiplier parts aviable for 16045 and 16145 on the net.
  13. 5211 PTO shaft removal

    hi gary were are you
  14. Next query: 6718 compressor

    hi @Brian . i have seen a lot of zetors with the air hose run straight from the compressor . you could use a quick release of a air compressor make sure the centre is out . and then a quick release on your hose. make sure on the other end the part that goes onto tyre is straight threw. so the...
Back
Top Bottom