Search results for query: *

Where did you get the wiring harness? I'm looking for one as well

I don't think that the rods matter as long as they are all the same way. Pistons should have an arrow to point to the front. If not then maybe someone else has some info

I would also like to find a set of fenders for a 4911

Yes pump is in gear. I tried in both the first two positions. The pto turns in both positions.

I bought the 4911, now is there a port where I can check hyd pump pressure directly off the pump? The hydraulic remote lever feels broken inside and does nothing and the three point hitch does not move. Lever is in correct position and oil level is up to the mark on the dipstick. Or should I...

I received it. Thank you.

Hi all. Im looking for a wiring diagram for a 4911. There wasnt one inside the hood. And the wiring is a disaster. Anyone have one they might share?

I looked at a 4911 today, only problem is that the hydraulic remote lever felt loose as in it did nothing, and the three point hitch didn't work. The pump was turning ( I could hear it) and it had oil in the transmission. I had all the levers in the right position. Any idea what could be wrong...

I'm just wondering if a 4911 and a 6945 have the same components from the clutch and back and if there are differences what are they? With the exception of the 4wd components of course. Also I'm wondering if the engine out of a 6945 will fit in a 7245 without too much difficulty. I'm pretty sure...

But there will be an updated Crystal II in the near future. Apparently this winter yet... For sure most of the problems you guys are talking about will be resolved.

I can only read the stamped numbers on the plate of my 6945. I can read one that says 1978. would that be date of manufacture?

Do you have the valve clearances as well?

Ok, thank you

As far as I know the forterras will stay with 4 cyl. The crystal will have the 6 and they will start at 175 hp. That's how I understood it.

Hi, Im looking for the head bolt torque specs for a 25K, as well as the sequence. Thanks

I picked up a used floor panel, the one that sits on top of the battery, and it has a raised piece in it. My old one was just a level plate, whereas this one has a piece about the size of a foot that sits up about 2 inches. Why is this? These are the right hand side of the tractor. And they have...

Hi. What weight of oil should i be using for the steering dampener on a 6945?

Does anyone know where I might find an aftermarket steering dampener? The one from Zetor is awful pricey. Way too much for a simple shock...

Ok. Thanks. Ja that seems to be gone. Can somebody post pics of what it would look like?

Hi. I noticed a small fluid resevoir inside the hood on my 6945. It is the same pot as the brake fluid resevoir, just below the side screen on the right hand side up by the front axle, bolted to the inside of the hood. It had a 2 ft hose attached to it that was just hanging free. What was this...