Recent content by tj_wolf2

Got them working. I knew the original problem was the MCs because I finally had some firmness in the pedal after changing the Master Cylinders and bleeding everything the pedals piston rod needed to be adjusted. hey are very touchy so a half turn does alot. Turned it too much and they locked...

From what I read on how to tell drum, to disc, to wet disc they are drum. I just found a guy that said he would look at it. Thanks for the help. I will post what he finds and all he does to it.

So I'm way off on what I need to do and where I am looking. No one around here really wants to touch this because they don't know what they are getting into. Is there easy way to check or fix before tearing everything apart?

Can I remove the covers to check if they are moving or is there a way to tell from the outside? Here are some pictures

Brakes not working on 3340. Replaced master cylinders, bled brakes and clutch with new fluid. I can pump up the brakes pedal, but no brake function. They are enclosed brakes, but told NOT wet brakes. Told the pads might be bad, or everything rusted after sitting for awhile. Any thoughts or...

Thanks I will try it out.

It is in the M position. I also have been putting the lever all the way down. I understand what you mean on that now that I think about it.

It is a Zetor system.

I have a Zetor 3340 and want to know what the weight capacity for the bucket? The manual only has the capacity for the 3point hitch.

I have a grader on the back of a 3340 and have been using it to clear snow. I need it to blade a dirt road and now the grader isn't digging in the dirt. Even on soft dirt it won't dig in just rides the top. I have it setup properly, but do I need the PTO pump on or anything else to make it...