• Hello Guest, you do not yet have the necessary rights to see the contents of our FAQ articles. Register in our forum, briefly introduce yourself and your Zetor in words and pictures and actively participate in discussions in the forum, then you will automatically receive access to the specialist articles in the FAQ.

Search results for query: *

  1. Zetor 5211 paint code for red?

    solved Zetor 5211 paint code for red?

    if u are in usa the chevrolet orange-red DE-1607 is about as close as it gets, painted my 5211 front panels with it.
  2. noise from left side after rear brake service, 5211

    noise from left side after rear brake service, 5211

    all bolts tight that were removed to service the brakes, pulled the left side portal/bull gear to inspect, thought the snap ring could have not been seated correctly but it was firmly in place, found nothing wrong so back together it went.
  3. noise from left side after rear brake service, 5211

    noise from left side after rear brake service, 5211

    i have replaced the brake shoes and cylinders, also the brake band, now there is a thump/bump sound coming from the left rear when i am driving on a slope, it only makes the sound when on a slope never on flat ground, all bolts are tight that i had removed for brake service, any ideals what it...
  4. Zetor 14145 engine oil pressure

    Zetor 14145 engine oil pressure

    those pressure's are ok [ 30-60 psi ] where u are loosing pressure when hot is most likely from the camshaft bearings.
  5. replacing copper seals @ motorpal

    replacing copper seals @ motorpal

    need to pull pump to replace the copper seals, will there be a timing problem if i remove the pump to replace seals and install the pump back ? 5211 3 cyl
  6. 3545

    3545

    battery fully charged ? have it tested to be 100% sure. does start button have and pass 12 volts when pushed, check it with a volt meter. next in the start circuit is the clutch safety switch, it must see and pass 12 volts when the clutch is fully down.
  7. Fuel delivery problems

    Fuel delivery problems

    carefull with starting fluid, start at tank, all lines to injection pump must be clear and unrestricted, does the lift pump work ?, are the fuel filters clean and passing fuel to the pump ?
  8. oil to the injection Pump on 5211

    oil to the injection Pump on 5211

    if the oil is drained from the injection pump it must be replaced before starting the engine, approx 10 oz was needed to quieten the cam and lifters in the pump, glad i was paying attention and caught it before destroying a pump. lack of solid information could very well be the death of this...
  9. oil to the injection Pump on 5211

    oil to the injection Pump on 5211

    ok, thanks. i guess then that if i drop the unused primer body away from the injection pump and fab a block off plate i will not have to fill the inj pump if oil spills out, correct ?
  10. Tach wiring and color code

    Tach wiring and color code

    maybe ur eyes are fading diy farmer, try adjusting ur screen color, no black on that connector.
  11. oil to the injection Pump on 5211

    oil to the injection Pump on 5211

    an oil line feeds oil to the injection pump, is that oil drained back to the oil pan thru the air compressor and into the timing gear cover ?
  12. Tach wiring and color code

    Tach wiring and color code

    more like wire color fading i guess, the blue and brown at the top is the + and -, the green and whatever on the bottom is from the sender @ the front of the engine, thats how i have it hooked up now and both the tach and hour meter are working.
  13. Tach wiring and color code

    Tach wiring and color code

    at that 4 wire connector there is no black wire, found out brown is negative and blue was power.
  14. Tach wiring and color code

    Tach wiring and color code

    in need of some help identifying the 4 wires plugged into the tachometer, the yellow and green come from the sender at front of engine. i have stripped the original wiring and gauges from the console, but are keeping the tach since its working, which is the 12v + and 12v - from this picture ...
  15. Engine dip stick

    Engine dip stick

    screwed in, or just compensate
  16. 5211 fuel pump mia

    5211 fuel pump mia

    the hose and routing was temporary, was waiting on fuel filters to arrive, the filters are now installed and the hoses corrected, trying to keep as original as possible but use an electric fuel pump.
  17. checking and adjusting the dual clutch 5211

    checking and adjusting the dual clutch 5211

    any simple procedure for checking and adjusting the dual clutch setup on a 5211 ?
  18. Project Zetor 5211

    Project Zetor 5211

    i doubt ill be out in the rain with it so a cab wasn't needed, the exposed electrics will be the gauges, which will be marine water proof, i am gona use a marine ignition switch [ off on start ] for diesel as well, but when stored it will be under a pole shed. from reading some of ur other post...
  19. 5211 fuel pump mia

    5211 fuel pump mia

    the fuel feed line is the one with the loop @ where the original fuel primer was, is the fuel injection pump a bosch unit, also what is the model # ? i have read the primers are known to be a problem with leakage so i intend to remove the lift pump and fabricate a block off plate, then move my...
  20. 5211 fuel pump mia

    5211 fuel pump mia

    anyone know the fuel pressure of the mechanical fuel pump ?
  21. 5211 fuel pump mia

    5211 fuel pump mia

    does that include the latest version also ? if so may try to find a good elect pump that could be more dependable.
  22. Project Zetor 5211

    Project Zetor 5211

    like i need another project ! picked up a 5211 to hopefully bring back to use, its been stored a long time outside, abused and neglected it is, had a blown head gasket # 3 cylinder and pushed out freeze plug @ left rear of block, those things have been fixed, painting the console and other...
  23. 5211 fuel pump mia

    5211 fuel pump mia

    thanks, should be able to get it corrected from that, wonder why it was removed.
  24. 5211 fuel pump mia

    5211 fuel pump mia

    bought an old tractor that is missing the fuel lift and primer pump, it has an electric pump fitted and does work for starting the tractor, should i put it back to oem, the manual doesn't indicate how the fuel lines should be connected, anyone know how the lines should be connected ...
  25. UR1 ZETORMATIC hydraulic manual free download link

    question UR1 ZETORMATIC hydraulic manual free download link

    What lang is the pdf when downloaded ?
  26. 5211 Hyd Lift inop

    5211 Hyd Lift inop

    eat my words, turns out the lever was not fully engaged, pto and hyd are now active, the screen was cleaned anyhow.
  27. 5211 Hyd Lift inop

    5211 Hyd Lift inop

    yes have the lever in the correct position, and the speed, also have the parts/owners/service manuals, pulled the filter for what i think is the hyds today and cleaned both the screen and magnet, still no movement, doesnt appear the hyd pump is working. can pics be loaded to post directly from...
  28. 5211 Hyd Lift inop

    5211 Hyd Lift inop

    Hello Zetor world picked up a 5211 that iam trying to get running again, hyd lift can be lifted by hand, think i have the levers in correct position but lift is not responding and i cant hear the hyd pump become active, fluid does have some moisture in it but the level is correct on the trans...
Back
Top Bottom