• Hello Guest, you do not yet have the necessary rights to see the contents of our FAQ articles. Register in our forum, briefly introduce yourself and your Zetor in words and pictures and actively participate in discussions in the forum, then you will automatically receive access to the specialist articles in the FAQ.

Recent content by mwburns

  1. "suire" power loaders on Zetors

    "suire" power loaders on Zetors

    Hi Gareth i had a suire loader on my 7245 but it was realy too heavy for the steering , well it`s now languishing in polland
  2. 5211 pulls to right slightly

    5211 pulls to right slightly

    Hi Don If you look in a previous forum post 6245 extremelly hard to steer left ixer0 tells you how to do it via the ram adjustment .:) Martin
  3. tyres

    tyres

    Hi renze I have 16.9 r 30 on the rear do you think they will match with the 12.4 / 24 `s ? , just needed to check that they didn`t get too close to the assister ram either but if you have them as standard they must be ok . Thanks for the help Martin
  4. tyres

    tyres

    Thanks for that renze . Has anyone ever tryed putting 12.4 /24 stomil tyres or anyother 12.4 `s on their 7245 ? thanks martin
  5. tyres

    tyres

    Hi all HOPE YOU ALL HAD A GREAT CHRISTMAS:) Does anyone know if you can fit 12.4 / 24 stomold tyres on to a 7245 , as a replacement to the 11.2 / 24 that are on there now . it does have a loader on if that makes any difference, any help would be great . thanks martin
  6. 7245

    7245

    Thanks renze , are you saying that the tractor has to be moving and reving at 1000 rpm for the asister ram to work on the steering ? is there anything you can add to the engine to free up the rings thanks martin
  7. 7245

    7245

    Hi , i have changed a large filter today that is in line between the underneath of the back end and the pump at the front , it`s quite big and cost 30 :o. is there still another filter under there that does the back end ? and does anyone else have one with these inline filters in there 7245 ? ...
  8. 7245

    7245

    Hi all just a few questions i would like answers to please 1 . where does the hydraulic filter go , if its underneath i presume you have to drain the oil 2 . does , the asisted steering only work well when you are moving as i have had the pressure checked , replaced the ram , new oil and filter...
  9. 5245 Power Loss

    5245 Power Loss

    Hi , check fuel lines, tank cap,sediment bowl ,lift pump gauze etc and when did you last change the filters ? , sounds like fuel starvation to me . does it start easily ? and what about after its stalled ,will it start again easily ? . :) thanks martin
  10. 5211...front wheel is loose

    5211...front wheel is loose

    Hi , remove the hub cap jack up the front wheel and support with a axel stand, then remove split pin and undo the large nut, check the bearing is good and tight and loaded with greese if so replace the bearings and wheel and tighten the nut untill there is a slight bit of top to bottom movement...
  11. Newbie needs advice on 6245 gearbox whine.

    Newbie needs advice on 6245 gearbox whine.

    Hi , if you remove the nut on the bottom of the 4wd lever and add a slightly larger nut as a spacer then replace the nut this will increace the spring tension and disengage the 4wd ,i had the same on my 7245 and this worked ,also spray a little wd40 on the shaft where it enters the side of the...
  12. 7245 starting

    7245 starting

    Full on the hand throttle and pump till you hear the hissing , sometimes 5 -25 times, works every time with my 7245 ;D ,no hissing no start >:-( , .
  13. 7245 what engine

    7245 what engine

    Hope you dont mind me joining in but on the question of the pto , why is it when the tractor is in gear with my foot on the clutch and i try and engague the pto using the hand lever there is a growling noise from the area below my feet and the tractor tries to drive forward, with it out of gear...
  14. 6211 goes harrowing

    6211 goes harrowing

    Thanks for the advice , the pump had no oil in there at all :o , but it didnt stop the hunting :(, there is however air bubles in the plastic conectors to the manifold and the pipe is loose at the manifold , do i need this heater thing ??? or could i remove it altogether untill i can get new...
  15. 6211 goes harrowing

    6211 goes harrowing

    Hi , thanks for the reply dave , the air filter has been cleaned out already , but the fuel filters have not been changed for years , everything else has been cleaned and changed , its only when put under load that it smokes , and it reves up and down on its own , from tickover to about 1000 rmp...
See more
Back
Top Bottom