Recent content by mikki69

How is the shuttle drive and new transmission working on theise tractors? I red on some sight that the transmission in the forterra was a bitch? And how is the fuel usage on theise models compared to other tractors. my 9540 used 50 liters when I was cutting grass on it for a friend on a big...

How are the proxima and forterra tractors working out? In Iceland they improted the last zetor in 1997/8 So we havent seen any of the new models in action. I am very found of zetor and have just started building up my mothers old farm so in the future I would rather stick to tradition and buy a...

So do you think this would be a mistake to replace the master cylinder with a bigger one?

thanks Renz Ill look into that. But this is what this company told me :http://shop.markomt.sk And the letter of response: Dear Mr. Brennan, I consulted your problem with our mechanic. If clutch plate is slightly warped, it is needed a higher stroke of work cylinder. Our mechanic fix it by...

Just for information if any one has the same problem . The steering end from the shaft betveen the weels has the same inside parts as the steering end on the hydraulic steering jack

Hi Doas any one own a workshop manual for zetor 9540? I would like to know how much the clutch slave cylinder should push out it goes out about 15 mm on my tractor but if it where to push fully out then it should go 25 mm I was andering if the wokshop manual says any thing about this?

Do they by any chance have a online parts manual for Zetor 7011? looking for a lot of parts for that one to And thanks for the zetor 9540 manual it gott me closer to what I was searching for :)

The dealers on Iceland say that these parts are not manufacture any more and are trieng to find a nother tie rod end wich has the same insides

Greetings fellow zetor owners Im having trouble (yes more of it) with the tie rod end on the steering cylinder on my 9540 Its welded onto the shaft so I cant replace it, and the parts dealer here in Iceland cant seem to find the parts to change inside of it , are there any other tie rod ends...

Could it be the exhaust or air intake valves ? I remember my old Volvo had a similar problem and it turned out to be the valves but that was a Volvo so I dont know it is the same problem just a thought .

Oh and to answer an old question No it doesnt seem to slip, it holds very well when ploughing or transferring heavy loads on a trailer .

Thanks Mike Then what could the trouble be ? A mechanic told me to hold the clutch shaft out while some one released the master cylinder back , I did that and then slave pushed all the way out and getting it in gear was easy but It didnt go as much back so it was always applying pressure to the...

I just put the tractor inside the garage yesterday and when checking the clutch slave I noticed that it has never pushed all the way out, there was about 5 mm missing and have from the beginning since in that area there was rust and dirt, I noticed that the master cylinder for the clutch on the...

Id really like to get a workshop manul and a parts list for this tractor Im rebuilding it .I think its a awesome machine, I was told the headbolts on these tractors where to thin so the gasket would always crack bu my uncles drilled it out and put bigger ones so there was newer any problem with...

are youa parts dealer